DesignCraft - Khối Xây Dựng Phong Cách Minecraft

They're building blocks!

Instructions:

• Print at 0.2mm with 0% infill.
• Let your imagination run wild!

Tips:

• Tolerances will vary between blocks and connectors depending on the filament used. I suggest printing the connectors with a few different filaments and finding ones that work best with different blocks.
• The connectors were designed with grooves so you can use your fingernail to insert and remove from blocks.
• Keep needle nose pliers on hand for tighter tolerances.
• Every block does not need to connect to every other block. Create strips of blocks and then connect to another strip with just a few well-placed connectors.
• You can also stack sections without the need for connectors. The pictured tower has about eight stacked sections which are not otherwise connected.

Companion Collections:

The following collections provide additional models within specific categories.

• Textured Slabs:  https://www.printables.com/model/545700
• Windows & Panes:  https://www.printables.com/model/545696
• Doors:  https://www.printables.com/model/545698
• Fences:  https://www.printables.com/model/545701

Notes:

• DesignCraft is a placeholder name for this project. The name may change in the future!
• The blocks used to make the pictured tower were all printed with PLA filaments.
• No glue, adhesives, or anything like that were used to create the pictured tower!

Credits:

• The build pictured was inspired by ItsMarloe's Amethyst Tower. However, I did take many of my own creative liberties! You can find his video here: https://www.youtube.com/watch?v=QI8hSyTASEc
• The Minecraft Spider model which appears in a couple of the images is by Steven786: https://www.printables.com/model/148963
• The stackable sorting trays I used to keep my blocks organized are by Mar Ber: https://www.printables.com/model/498070
• The organic catchall tray I used to hold my connectors is by lord_edel: https://www.printables.com/model/380742