Chân đế thay thế cho đầu đĩa than Pioneer PL-518

This is a replacement foot for a vintage Pioneer PL-518 turntable. It's roughly modeled after the ones sold by Mnpctech and should fit other vintage PL-series turntables using the same style feet. These are meant to use the factory screws.

I opted to use TPU to hopefully give these a little better vibration dampening since they aren't spring loaded like the factory ones, but you can theoretically print them out of whatever material you like. Perhaps stick a felt or rubber pad on the bottom so they don't slide around.

Print Settings

• Printer: Voron 2.4R2 250

• Rafts: No

• Supports: No

• Resolution: 0.2 mm

• Infill: 15 - 20%

• Filament Material: TPU