Bộ chân đế phong cách Rocket R58 cho Rocket Appartamento

Print on the outside face with no supports needed. Standard .2mm layer height PLA settings work well, but I would recommend bumping up to 3 layer wall thickness.

I heavily recommend installing the feet printed with TPU, otherwise the machine will want to slide around

Uses the threaded studs from the original feet, just take a 5mm allen wrench to remove them (they may be on pretty tight). Break in the plastic threads by first insterting the threaded studs into the new feet, then remove them. Then reinsert the threaded studs into the machine while holding the new feet in place. The front feet you can install the stud from the top. The rear feet should be installed from the buttom.

The front and rear feet have slightly different locations for the threads to improve fit, but the photos shown use the same part for all four feet (front.stl)