Bảo vệ kết nối Dupont cho Elevated Sensors Bed Presence (ESPHome)

Slightly more robust than zip ties, or painters / gaffing tape alone to protect the sensor strip Dupont connections for the Elevated Sensors Bed Presence for ESPHome when using the wire extensions.

My thick foam mattress has to be slid on and off the frame & slats due to weight and I was worried doing so would rip the connector off the sensor strip when being moved around.

This design fits neatly over the Dupont connection point and is as low-profile as it could be safely made and still be structurally strong. It can be taped or zip-tied down over top of the connection. It should not interfere with the function as it allows the sensor strip to still properly vent.

• Printed in PETG, but PLA, ABS, ASA, etc. would probably also be fine

• Oriented in the slicer with the finished upper side down on the build plate

• OrcaSlicer or similar 0.20mm "strength" profile

• No brim

• Arachne walls

• 20% gyroid infill, although the part is so small it basically doesn't matter