Nâng cấp cho Hộp Sấy Filament (Upgrades for Filament Dry Box)

Print instructions for "fullbody" roll adapters with open faces

So you want to print the proposed open-faced roll adapters? Here is how: 

1. Rightclick on your part and add a cylinder modifier. Change its X and Y size to the diameter of the the roll adapter you want to print minus 2x your perimeter thickness. You can find that value in “Print settings/Layers and Perimeters” in the lower part of the "Vertical shells" dialog (it says recommended thin wall thickness).

   In my case I want to print a 54 mm roll adapter with 2 perimeters. The recommended thin wall thickness for 2 perimeters is given as 0.86 mm so I substract:

   54 mm - 2 x 0.86 mm = 50.28 mm

   This means my modifier has to be 50.28 mm wide and deep.
    

2. As your Z size put value bigger than 21.5 mm (that's the total height of the roll adapter) and then center your modifier, in my case that would be 90/90/11 in the "Position" dialog.
    

3. Then rightclick on your modifier and choose the option "Layers and Perimeters". There, set your bottom and top solid layers to 0.
    

4. Slice your part and have a look at what it will look like. Maybe play around with the infill pattern and density. In my case I went with the honeycomb pattern at 15% infill