Chân đáp GEPRC Cinelog35 V2 (Landing Gear)

I recently built my GEPRC Cinelog35 v2 when I noticed that the motors were touching the floor when I was setting the cinewhoop on the ground. I needed a solution for that problem.

I have found a few designs, but none of which I was happy with.

So I came up with my own design, that just comes in at ~2g per feet, so it keeps your whoop clean and lightweight.

The best way to put them in is to slide them in from the side. Apply pressure from inside and outside of the protective cage. Be patient and dont use excessive force.

Print the file in the same orientation as it comes.

I used 3 walls, 10% infill and tree supports.

Have fun!