Ikea Lack Stack – Bộ nối dài chân 15 cm để xếp chồng

I designed two versions, the original is designed to be tightened with a screw from the inside to have seamless corners on the outside. The second (named “Mirror”) is the opposite, where the screw holes are on the outside. After designing it myself, I found out it was very similar to @Wossi1975_403070 design, but decided not to consider it as a remix. The screw holes are 4mm in diameter.

If you are interested in the Leg Risers for the bottom table, Click Here.

Print Settings:

• Filament: I recommend PETG, but PLA will be fine
• Layer Height: 0.3 - 0.35
• Perimeters: 3-5
• Top & Bottom Layers: 3
• Infill Pattern: Gyroid/Cubic
• Infill Density: At least 5%, I printed with 7%
• No supports needed