Giá treo cuộn giấy vệ sinh gắn tường (wall mount)

Needed a non-pegboard version of my toilet paper roll holder. Most folks don't appreciate the usefulness of TP as a tool for quick, small cleanups of things other than poop, but I do so keep rolls of TP handy wherever I might otherwise need to waste a full sheet of a paper towel.

Of course, if you actually need a toilet paper holder for the bathroom, no reason you can't use this one. Only possible issue is I didn't make any effort to conceal the screw heads so I'm guessing there are ones out there which will look more "finished".

This holder addresses the issues I had another one I had used, and has a better overall fit. The flip-up holders can't flip all the way up so won't get stuck vertical. I think it also looks a little nicer than the previous design.

One note - this was designed with a uniform 0.2mm clearance all the way around. I'm constantly being told that my designs "don't work" and my only guess is when they work for me and not for you, you very likely have a printer that isn't properly calibrated. If this winds up being too close for you and it "doesn't work" maybe spend a little time learning about printer calibration before blaming my design which does, in fact... work.

Print Settings

Been a long time since I designed this and many printers ago, but looking at it, I'd say just about any layer height would be just fine, and you probably don't need to beef it up with additional shells or upping infill. Definitely turn on supports from the print bed so the wings are supported otherwise that will all fail.