Hộp chứa đồ gắn lưỡi xe kéo TRX4m (TRX4m trailer tongue box)

This is a storage box for the tongue of the Traxxas trailer for the TRX4m. It_should_ fit on the tongue where indicated by picture four, without need for trimming or adhesive. I will print this soon, and update this listing as soon as I have post-print photos. Hopefully it is all measured right. The lower parts should fit right into the cutouts of the tongue, and should be pretty snug once fitted in. The lid should fit on top by friction, or you could keep it on with a rubber band.

I think the easiest way to print will be the way I've configured it, which will require supports on both the bottom of the box and the bottom of the lid. Cura is saying just shy of three hours and 32g of filament for this print at 15% infill with tree supports. However, it only gains ~ten minutes and 3g to do 70% infill, so really however solid you want it to be, you can do. You shouldn't really need to print anywhere over 25% infill.

If you print this, please post a make! It helps me gauge community engagement and know what I need to do better. Your feedback is incredibly helpful to me!

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

**Rafts:**

Doesn't Matter

Supports:

Yes

**Resolution:**

Normal resolution should be fine.

Infill:

15-20%

Category: R/C Vehicles