Bộ kẹp quản lý dây cáp dưới bàn

Created these to manage the cables under my desk. 

Two versions, one for up to 6mm cables and another for up to 8mm cables. Each in a version that will hold 2 cables or 6 cables.

Can be printed in virtually anything. I've tried PLA, PETG and PBT and all of them work fine and are more than strong enough.

There's two screw holes for securing these but you could potentially also use double-sided adhesive like nano tape or glue, depending on the strength required.

Important: Printer tolerances

Tight tolerances can vary a bit between printers and filament used. For this reason the design includes two variants of the “CableTie”, a normal one and one called “LooseFit”. The latter has slightly larger tolerances and will result in a more loose fit. Ideally print one of each to figure out which one works best for your printer and filament.

Print settings

Print all parts on the side (as seen in image 4) with several walls/perimeters so it is more or less a solid print. 

Problems, questions or feedback?

Please don't hesitate to reach out and we'll get it sorted. Thanks!

If you need one that can hold a specific number of cables or a specific thickness, or something else, let me know and I will likely add it to the collection.