Ngăn kéo/Bộ sắp xếp đồ từ cuộn nhựa cũ (3 ngăn)

This model was made so that you are able to reuse your filament spools without throwing them away. It only uses about 200 grams of filament, so it makes a good last meter print. It fits in every spool Ive tried it on. The pegs that are apart of the print just insert into the bottom of the print like dowels, the tolerance is very low so you might have to push fairly hard to gt it in there. Though you have to drill holes to make it so you can insert the tabs to rotate the drawers, a drilling guide model is attached with the main model. This model works best with plastic spools because paper spools just kind of shred when you drill into it, (though I was using a hand drill to make the holes so if you use a power drill it might work.)