Mini ITX PC Case - Bản Remix hỗ trợ gắn thêm HDD/SSD

This is a remix of makerunit's Mini ITX PC case with support for a HDD & space for several SSDs.

(If you make one, please upload a make! it is very much appreciated! Thank You.)

What I changed:

• Made case 2cm thicker.
• Made back panel 2cm taller.
• Added HDD mount to top panel.
• Added no power button version.
• Added vents to back panel.
• Tapered Motherboard supports to allow mounting Motherboard directly to case without standoffs.
• Added Lowered back panel version for use with mounting motherboard directly to case.

I really liked this minimal case, but i wanted to use it as a remote backup server, so i added support for a HDD & due to the case height you can also mount several SSDs on the internal walls (with double sided mounting tape or command adhesive strips). I lowered the Mobo to give a little more breathing room for the cpu cooler. my board & cooler are rather low profile, so please check your measurements before printing.

There is roughly 46mm between the top of the HDD & the motherboard supports if mounting directly to the case & using the Rear_Vented_Lowered back panel.
There is Roughly 40mm if using the 6mm standoffs that makerunit's design uses.

Make sure you use the Rear_Vented_Lowered back panel if you are mounting directly to the case & want the 46mm spacing.

Thank you makerunit for your fantastic design!