Đế sạc Samsung Galaxy Watch 7, 6, 5 gắn màn hình

Samsung Galaxy Watch Monitor Charger Holder (Watch 7 / 6 / 5)
Clean and simple holder for the original Samsung charging puck. Designed to be mounted on your desks monitor. Specifically for Galaxy Watch 7, 6, and 5.

🛠 Design & Fit

This holder is made to fit the official Samsung charger perfectly – third-party pucks won’t fit. The puck snaps in tightly and stays in place thanks to the stiff cable end pressing against the back wall. 

The model is fully support-free and prints best flat on its large backside. Thanks to the wide contact surface, no brim or adhesion helpers are needed. 

🖨 Print Settings (tested)

Material: PLA
Nozzle: 0.4 mm
Layer height: 0.2 mm
Supports: none
Infill: 15%
Orientation: back side down on the build plate

🧲 Mounting

The holder can be attached to your monitor using double-sided tape – as shown in the photos.