Bộ chuyển đổi BCAR cho Boxer Pro

IMPORTANT

Since this part will show some color on the outside of your blaster, please print this adapter in orange or bright colors if you plan to use your boxer outside.

I only considered the X-Shot BCAR that came with the motorized piston pump when designing this, so I have not tested any other BCAR's compatibility, and most other BCARs will not be compatible. 

I created this BCAR adapter to take the standard X-Shot BCARs (such as the one found in the MPP), and use them in the boxer pro, without opening or cutting the blaster, and allowing you to take out the BCAR when not in use. The BCAR should add some accuracy to the boxer pro and theoretically decrease the fps of it (I have yet to chronograph the difference). The BCAR just fits into place on the adapter and the whole adapter goes into the front of the boxer. This means you do not need to open or cut into your boxer pro! The adapter clips onto the front of the boxer pro, and if it falls off the front due to poor tolerances, too much friction from darts, or swinging around a lot, you can fix this by adding a layer of electrical tape or another sort of buffer between the outer orange original boxer pro barrel and the adapter.

Print Info:

• 0.2mm layers

• 10% infill

• 2 walls

• Pre-orientated

• No Supports