Bìa PSU cho Anycubic Kobra Go với quạt 92mm

This is a replacement cover for the OEM PSU in the Anycubic Kobra Go. It allows the use of a standard 92mm fan instead of the noisy 60mm OEM fan.

Easy to print, holes will line up with existing ones. Mounted to the printer by reusing the original cover screws.

You will need to install higher feet on your printer, otherwise there is not enough clearance under the PSU for the fan. Feet height will depend on the thickness of the fan you install. The one in the picture is a 14mm thin one (Noctua NF-A9x14) and it's about 1mm too thick to fit under there.

Warning: The Anycubic Kobra Go is 24V only. Noctua fans (and most PC fans) are 12V only. You will need to supply 12V to the fan or use a 24V fan.