Pháo đạo cụ kích thước thật (Life Sized Prop Cannon)

This is a full sized prop cannon that can be printed on a standard i3 sized printer.

The main parts of the cannon are labeled A-G and should each be printed once.

Dowels are included to help with aligning and joining the parts. You will need to print 4 small dowels to join parts A and B, but all other parts will be joined with the regular dowels.

The cap on the rear of the cannon can be glued in place, but there are also slots for 4 rare earth magnets which allow this cap to be removed if needed. 

Two handles should be printed which slot into the holes on part G.

Part F has an opening at the bottom which can be used for running things into the rear of the cannon. In our case we used this opening to run fog and compressed air controlled by a solenoid valve which lets us shoot fog out of the end of the cannon.