Mặt Nạ Hollow Knight Cho Halloween

I wanted a simple hollow knight face mask for Halloween that can be easily taken off / moved to the side as opposed to the large head masks. I'm wearing this mask with a wig underneath, and with black fabric on the inside of the eyes, though black mesh would also work. There are holes on the sides so you can tie string or elastic cord to the mask.

This model is remixed from RobJP_ 's Hollow Knight figurine. I used the head, cut it in half, flattened it, hollowed out the inside and eye holes, and added holes for string or elastic. I loved the style of the figurine, so a huge thanks to them! The character was designed by Team Cherry, so major thanks to them as well for two wonderfully difficult games.

Orientation - I printed the mask vertically so that there weren't any print lines on the center of the face. If you don't mind the lines or plan to sand / finish it, you could definitely print it horizontally.

Infill - I would recommend a very low infill to keep it lightweight.

Supports - This model needs supports. In the third image I show where I added paint on supports, which are on the tops of the eye holes, the top of the head, and a little bit at the very bottom of the mask. There is mild bridging at the top of the horns but my printer was able to handle it fine. The holes for the string / elastic are diamonds, so you should not need supports inside of those.

Scale - The full model is just under 10 inches. Feel free to resize as needed. You need quite a large printer to print it at full scale, so you might also want to cut it so that the horns are separate pieces.