Hộp đựng gel Silica có nắp trượt (Vừa vặn với IKEA Samla 22L)

About

Remix of the silica gel box:

• Adjusted for better fit in IKEA Samla 22L box
  • Samla 22L has a bottom size of 300mm x 216mm (measuring the largest usable rectangular surface)
  • This box's dimensions are 146.4mm x 100mm
  • This means you can put 4 of these inside with less spacing between them than the original one
• Minor optimizations (for more usable volume & fillament savings with minimal impact on sturdiness)
  • Bottom height reduced by 1mm (from 3mm to 2mm)
  • Lid height reduced by 1mm
  • Height of the box's inside raised from 12mm to 21.40mm (total height of 27.4mm)

Should fit almost 200 grams of white silica gel.

Print settings

Printer:

Prusa MINI+

Supports:

No

Resolution: 

0.2 mm

Infill:

20% (Rectilinear)

Filament: PETG (Prusament Prusa Orange & Fiberlogy Orange)

More details

Go to the original model's page for mode details (eg. threaded vs inserts):
https://www.printables.com/model/81318-silica-gel-box-with-sliding-lid-for-100-g-gel

I've prepared both threaded & insert versions with my modifications, however I myself did NOT print the threaded version, only the insert one, so in case of any problems, please contact me about this and I'll try to fix it.