Giá Đỡ Giấy Cuộn Thơm (Paper Towel Roll Holder)

After making some slight modifications to the geometry of the project, this now prints in 3 parts. The top is built with a simple print-in-place hinge attaching the command strip mount to the roll cap (you may need to work the hinge a bit to make it smooth). The support mount is designed to fit into the holes on the underside of the base plate, with the command strip attachment point fitting through completely. Due to the orientation of the parts, gravity and friction might be enough to keep everything held together, but I would still recommend glue if you have the option.

Some notes on printing: The arms of the hinge the intersect the cap is not attached to anything and will need supports to print correctly. The base plate support mount will also need supports in order to print correctly. The holes in the base plate are designed to be 0.5mm larger in width and height than the studs on the support mount, although you may need do some sanding depending on your printer's tolerances.