{"slice":{"locale":"en","from":20000,"to":32029,"total_chars":32029,"html":"<p>D/OR petals with holes. Up to you. All petals have the holes to mount the lights. Fasten everything together using the #10-32 x 1in. screws.</p>\n<p>It's been observed that sometimes water drips out of the lid. This is sometimes due to capillarity and condensation. The only way to mostly solve the issue is to add some sealant (such as silicone) between the petals when assembling the lid together. I'd also advice to put a plate under the reservoir to catch any accidental spill.</p>\n<p><strong>How to Operate the Tower</strong></p>\n<p>I will write a short &quot;manual&quot; on how to maintain and operate your tower. This section is still a &quot;work in progress&quot;. However, I'll start posting as soon as the paragraphs are ready.</p>\n<p>Firstly, it is recommended that you do a full water change every week, in order to reduce the chance of pests and diseases and the build up of waste. When filling up the reservoir during the water change, add fertilizer as directed. Initially, during the early growth period, don't use the full fertilizer does, as you could kill the young seedling. Once the plants mature, you can go to full strength. After you add the fertilizer, check the pH of the water in the reservoir and adjust accordingly, small amounts at a time. Always check before adding more. The pH will depend on the fertilizer dose and the natural pH of you tap water. I usually have to use pH down (not too much) since my water has a pH of 8.</p>\n<p>During the week, you'll have to keep an eye on the water pH. Adjust as needed. You should also keep refilling the reservoir as needed so the water level doesn't go too low. Remember, you cannot run the pump dry! During the early growth stages, the level will barely go down. However, once the plants mature, you might have to add up to a gallon of water a day. I currently have 40 plants growing on my tower and they consume almost a gallon (around 3.76 liter) a day! I add water with some fertilizer and always check the pH. With these many plants, the pH will swing substantially. If you want to always have the pH under control, this reservoir is too small and you'll have to limit yourself to 12-15 plants max. I've consistently run this tower with almost 40 plants for months and despite the large pH swings the plants seemed unaffected and grew fine. But you'll have to decide for yourself.</p>\n<p>Once the plants grow, the roots will start filling up the tower. Eventually, they'll find their way down to the reservoir. Even though I redesigned filtration unit to prevent as much as possible the roots from accessing the reservoir, the filtration mesh I'm using (which is a window screen) is not fine enough and the roots will eventually go through the holes or the sides and enter the reservoir. Thus, regular maintenance is a must. This is discussed in the next section.</p>\n<p><strong>Maintenance</strong></p>\n<p>Although minimal daily interaction with the tower is required, some maintenance and checkup is required.</p>\n<p>Daily maintenance:<br>\nNot much is required to do daily. Depending on the growth stage, some things you might want to check every day are:</p>\n<ul>\n<li>Water level: At peak production, you might have to refill the reservoir with nutrients and water daily. 40 plants can use all the water in the reservoir if growing healthy.</li>\n<li>Pollination: Yes, if you manage to grow flowering plants, you will have to pollinate by hand. Different plants are pollinated differently by hand. Always goggle it first. For example, to pollinate tomatoes gently shake the plants a few times a day.</li>\n</ul>\n<p>Weekly maintenance:<br>\nAt least once a week, you'll have to do:</p>\n<ul>\n<li>Water change: Completely change the water in the reservoir and refill it with fresh water and nutrients. Always make sure the pump is unplugged to prevent it from accidentally running while dry.</li>\n<li>Check for leaks, mold, undesired growth or other issues: Use your common sense and check for any issues that could get worse. I know it's pretty vague, but you'll quickly get a sense of what I mean.</li>\n</ul>\n<p>Minor maintenance (every 2 months):<br>\nThe best way to keep the tower running without leaks and diseases is to conduct a minor maintenance every few months. If you do this, you'll be able to postpone substantially the major headache that disassembling the tower represents. The biggest issue here is to keep the root growth contained. I'll explain how I do it. You should decide whether you want to do it too or you'd rather disassemble the tower and do a deep clean.</p>\n<ul>\n<li>Root removal: The idea here is to remove most of the roots inside the reservoir and the base spacer. Without disassembling the tower, it is tricky. But it can be done. You'll need either a long pair of tweezer or chopsticks (my personal favorite). Here's how it's done:</li>\n<li>For the reservoir: Use the holes in the lid to access the reservoir. Empty the reservoir and disconnect the pump. Now, use the tweezers to remove the roots. If using chopsticks, the best way to do it is by pinching and turning, as if the roots were spaghettis. By turning you'll grab a considerable amount of roots. Then just pull them out. You don't have to get rid of all the roots, but the more the better.</li>\n<li>For the base spacer: Similar to the reservoir, but now you'll have to access it from the holes in the planter module immediately above the spacer. Again, try to get rid of most of the roots there without damaging the screen.</li>\n</ul>\n<p>Major maintenance (every 4-6 months):<br>\nThis is the not so fun part of hydroponics. Every few months or so, depending on the height and number of plants you are growing, the tower will need major maintenance. This basically means disassembling the tower, cleaning it and reassembling. I know it's tedious and takes a few hours, but it will be for the better. For can sill do it while growing plants. However, this makes it more challenging, since keeping the plants intact while disassembling the tower it's messy and not easy. But it can be done.</p>\n<ul>\n<li>First, unplug everything and remove the growing lights.</li>\n<li>Empty the reservoir completely.</li>\n<li>Remove or harvest as many plants as you can. The fewer plants you need to keep the easier it's gonna be. Also, if the plants are at an early growing stage it's gonna be easier. Some plants might be too big and break when twisting and moving the different parts. Keep that in mind.</li>\n<li>Now, remove the top cap and the internal dispenser. Cut the tubing that's attached at the internal dispenser.</li>\n<li>Now remove the top module. To do so remove first the pots. If you are keeping a plant, remove it carefully and trim the roots a bit. Once you have removed all the plants, clean the module and remove any remaining roots. The idea is to get rid of anything that could rot or clog the pump.</li>\n<li>Keep removing the modules, one by one.</li>\n<li>Once you get to the lid, remove the lid to access the pump. Wipe the inside op the pot and clean the pump filter.</li>\n<li>Now, start reassembling the tower.</li>\n<li>Congrats, all done!</li>\n</ul>\n<p><strong>Plants &amp; Other Progress Updates</strong></p>\n<p>First things first, it's my first time dealing with hydroponics. I have previous experience with gardening and growing vegetables, but I'm not an expert. My idea was to use this tower to learn and experiment with hydroponics. Hopefully other people will share their experiences too so we can all learn which plants grow best and the best settings.</p>\n<p>Initially, I decided to only grow leafy greens and herbs. They have similar nutrient and light requirements, so I though that would make it easy, at least initially. These are the plants I initially planted and my experience with them:</p>\n<ul>\n<li>Bok Choy: They are doing great. So far, these have seen the strongest grow and seem to be thriving. They were also the strongest seedlings. One thing I want to look into is whether their location (at the top of the tower) has something to do with it.</li>\n<li>Lettuce: I tried different lettuce varieties, and all seem to be doing fine. Their growth seems slow at first, but don't be fooled. If you plant too much you can easily overproduce. If you wait too much to harvest them, they will bolt. They grow fine with 6 lights and are not leggy at all.</li>\n<li>Swiss Chard: Slow growth. Not much leaf production before it bolts.</li>\n<li>Cilantro: My experience has not been positive really. Doesn't produce many leaves before it starts bolting.</li>\n<li>Parsley: It took really long to spout (no surprise there), but it eventually grows abundantly. With a couple plants you will never run out of parsley.</li>\n<li>Spinach: Somewhat tricky to sprout. They need a cold room to sprout, which means that they cannot be planted directly in the tower since the room is not cold enough. Once sprouted and transferred, they do good but and produce abundantly.</li>\n<li>Chives: Their growth has been minimal. Provably due to a lack of light.</li>\n<li>Arugula: Pretty disappointing at first. Initially, it looks like they are trying to survive rather than grow. Once it grows enough roots, it really takes over.</li>\n</ul>\n<p>All in all, I already expected some challenges due to growing indoors. I think if I can figure out the right amount of light, the sprouting and transfer methods and the watering schedule, things can improve.</p>\n<p>Initially, I used 3 LED grow lights for 16 hours a day. The pump was scheduled to run 30min on and 45 min off. During the night, the pump was off for longer, about 3 hours (when there is no light plants do not require as much water, just to keep their roots wet). The growth was decent, but I could see some plants struggling, such as the parsley and spinach. The lettuce was growing fine, but there was some lack of pigmentation on the red varieties, which seemed to indicate an insufficient lighting. Therefore, I added the other three grow lights and reduced the light schedule to 12 hours a day.</p>\n<p>With 6 LED grow lights, the growth is greatly improved. I didn't realize how much the tower can produce until I used all 6 lights. The lettuce is thriving, and all the other plants are doing better. Definitely use 6 lights if you can.</p>\n<p>Now I've started experimenting with flowering plants:</p>\n<ul>\n<li>Tomatoes: My first try was at cherry tomatoes. You really have to check how much the variety grows so you don't get overrun by the plants. But tomatoes seems to grow fine in the tower. So far they've flowered and I've been able to pollinate them by tapping gently on the plant stems so the entire plant &quot;vibrates&quot; and the flowers self--pollinate. I have dozens of cherry tomatoes maturing right now. I've also harvested a bunch. These vines are really productive and don't really stop producing if you keep harvesting. They taste great and have no issues with pests. The only reason why I end up removing the plants is because they get either too big or start producing only small tomatoes.</li>\n<li>Peppers: After the successful experience with cherry tomatoes I' growing peppers and chilies. They grow nicely and vigorously. I don't have to worry about pests and they are pollinated like the tomato plants. I've tried dwarf varieties and bigger ones. The dwarf varieties are easier to take care since they grow slowly, but are less productive. Larger varieties (plants that grow up to 2 feet) have to be trellised but produce substantially more. To trellis them I use jute twine and either anchor it at the tower to at the LED lights. Since the pant is not too heavy I'm not concerned with destabilizing the tower. I've obtained a lot of peppers so far.</li>\n<li>Wild strawberries: I decided to grow the smallest possible strawberries, and thus I settled for the wild or European strawberry. I started them from seed and they took a few months to grow. They started producing fruit after 4-5 months and have been flowering continuously since then (as of February 2024). I've found that the best pollination technique is the same as with tomatoes and peppers: Shaking the plant. I just &quot;pet&quot; the plants daily. After a week the flower is properly fertilized and produces nice, tasty and small fruits. Since the flowers are usually hidden, just keep checking and petting your delicious pet! Otherwise you might miss some. They quickly go bad after ripening.</li>\n</ul>","has_more":false},"deferred":false}
